Tricks – Page 107 – MagicShow.Tips

Triumph Clean Up…

I’ve been fascinated by the idea of using the old card production where you drop the deck of cards on the table and the top card flips over as a “clean up” for card trick triumph. By clean up, I mean the last thing you have to do in my sequences where you need to reverse one card…or half of the deck.

In the past I’ve published a fairly complex version of Triumph that used a stripped deck and had a kicker ending, but used the flip over production to clean up the deck for the reveal. About a month ago, I think I finally hit on a sequence that makes sense, and it’s pretty simple, I’m surprised I didn’t think of it earlier. Here it is:

Card is selected and returned to the deck, but secretly controlled to the top.
The bottom half is flipped face up and you are going to do a modified zarrow shuffle. You will shuffle all but the top card (selected card) of the face down half into the bottom half of the face up cards. Then run about a quarter of the face up cards, drop the final face down card, and run the remaining face up cards.
You will now strip out the face up cards, but add the face down selection to the face up cards, so they to on top.
Find the natural break between the face up and face down halves. Side jog the face up half and drop it on the table. They should flip over, giving you deck that’s all face down except for the face up selection!

That’s it. While the shuffle procedure reads fairly complex, it’s not. If you can do a Zarrow Shuffle, you can do this.
-Louie

Double Cupped…

One thing that drives me nuts is when I go to coffee shops and they give me a to go cup that’s double cupped. To me it feels wasteful to give me two cups, when one will do the job. That inspired me to mess around with a way to make the second cup disappear.

The method that I came up with was pretty simple. It’s the top inch of a cup and only half of the “circle”, and this makes a sort of a shell for the top of the front of the outer cup. If I held the cup so that my hand covers the bottom of the shell, it looks like a coffee cup that’s double cupped. I can also lift the top cup up and it creates the illusion that the two cups are separate. For the vanish I simple need to steal this little shell for the vanish.

The hard thing is to figure out how to ditch the shell. My idea was to palm the shell as I take the lid off of the cup. That still leaves the actual ditch of the shell, I think if I put the lid into my table, then it’s out of sight out of mind.

So now the second cup has been stolen, and the audience doesn’t know that yet. How do I reveal it? Maybe I could produce a cup and then call attention to the original double cup is now a single cup?

Honestly, I don’t know how to end the trick. I will say that this is probably a trick I’ll never do, so I don’t know how much energy I’m going to put into figuring it out.

-Louie

Hiding The Second Card…

A couple of weeks ago I was on an airplane and messing around with some cards. I was thinking that there wasn’t (that I was aware of) a false count like an Elmsley Count or Jordan Count that hid the second from the top card of a face down pile. After playing around a little bit I came up with a count to do hide the second from the top:

Count 1: Push off a double
Count 2: push off a single with the left hand. The right hand buckles the bottom card and when the card from the left hand covers the right hands cards, the the left hand steals the top card of the right hand’s pile.
Count 3: deal one card
Count 4: deal one card

That’s it, pretty simple. There’s not much to it. I think the reason not many people have explored a count that hides the second from the top card is that you have pretty much have to start with a double push off. This isn’t the easiest thing to do…it’s not crazy hard, but hard enough to scare away people.

I will say there are probably better ways to hide the card second from the top of the deck. I will also say it was a fun way to spend some time on a plane!

-Louie

Let Them Show You…

The amount of magicians that complain when people want to show them a magic trick is staggering. I don’t get it, why not let the person show you?
The person will be the star for a minute, and I think that’s where the problem is, most magicians have a ego that won’t let them step away and let someone else into the spotlight.

At a gig the other night a someone wanted to show me a trick and I say “yes”.

They did the trick with the glide where at the end the slap the cards out of your hand and one card is left in your hand and it’s the selected card. When I let her do it, she nailed it! That’s going to be one of the memories from the party for the dozen people that say it, and something they’ll talk about longer than my roving set.

I’m not saying you should 100% always let the person show you the trick. There are times when it’s inappropriate, like in the middle of a ticketed formal show. but if you’re roving or after a show, why not? It’s not going to hurt anything.

-Louie

Roving Magic…

There’s an old piece of advice that (usually older) magicians give newer magicians. That is, “you only need to know 8 tricks” and that you should know those tricks inside and out. While that advice may have be relevant over 100 years ago when it was originally given. I think the story was a kid said to Thurston that he knew over 100 tricks and Thurston replied, “I only know seven” or something like that.

Here’s the problem with that advice, look at every modern successful magician, they all know and do more than seven or eight tricks.

Now let’s apply that to the average magician. Yesterday I performed at a company party for people in healthcare. I was hired for an hour of roving magic, and normally I’ll do the same 5ish minute set over and over for the hour. However, this party spanned several hours and the worker came to it when they were free. When I was there the first 30 mins was busy, but the final 30 mins was just about 8 people (who had seen my set in the first 30 minutes of the party). If I only knew seven or eight tricks, I’d be screwed. However, I have a big toolbox of sleights and tricks, I was able to pull out some things I don’t normally do and to improvise.

In the picture above I’m doing Jack Carpenter’s Mysterious from the book Modus Operandi. This is a trick I’ve done since I was a teenager, but it’s not in my roving set because it uses a table, and some specific cards. When I do roving magic, my deck loses cards very quickly, so I can’t always guarantee that I have the needed cards.

The moral of the story is to fill your tool box, if all you have is a 3/8 inch wrench and a hammer in it, you’re in trouble if you need a phillips screwdriver!

-Louie

Mish Mash Wallet

A few weeks ago I ordered a custom designed wallet that had playing cards on it (you can read about my card wallet here). I had totally forgotten about it, until it arrived yesterday. It was a fun surprise!

Here’s the wallet:

This wallet is essentially Harry Anderson’s MishMash card design, but set up like John Kennedy’s Mind Power Deck! I’m happy with how it turned out, however if I was going to make another one, there are a few small changes. Right now it’s a way to force one of 8 cards, then a fishing procedure to know the card.

I’ve got an idea to then have the card appear in your wallet, with no sleight of hand! I’m going to play with this idea later this week!

-Louie

Catch a Show…

As I’ve gotten older and deeper into my career, I’m learning to take more days off…more days when I could be earning a lot of money. A friend of mine who is a magician invited me to his company’s Christmas party and there was a magician there. It was James Donahue, who I know from the social media, and I’ve made a prop for him in the past, but never met in person.

It was great to see him work for actual people.

Something I always say is that if you want to really work an industry you need to be a consumer of that industry. What I mean by that is it really helps if you can see what your show looks like form the attendee’s perspective.

Every now and then, taking a night off and seeing someone else do what you would normally be paid to do is a great chance to learn a lot!

-Louie

Working on a Briefcase Show…

A while ago I started thinking about putting together a “briefcase magic show”. This would be a show that would fit in a briefcase and have minimal set up and take down. Ideally there wouldn’t be much more set up than simply opening the case.

You can read my previous post about it here.

The end goal would have this show as a totally different show from my normal show, so there is no duplication between the two shows. Right now the set list I’ve written for it is:

Ruler prediction
Choices Card Trick*
Ball of Yarn*
Lotto Prediction
Spoon/Fork/Knife*
Game Show
Vanishing birdcage

The things with the asterisk after them are tricks that are also in my current main show. That means I need to figure out how to either move them out of the main show, or out of the briefcase show. It’s a fairly mentalism heavy show, with 4 predictions (if you count the card trick as a prediction).

I think I might need to add another magic trick to it…not sure what. I guess that means it’s time to get to work on that.

-Louie

Fun Pics….

I’m always on the look out for fun photo ops when I do my show. One of the things I do is the three shell game, and whenever I see police officers, I always try to get them to play it.

With everyone now having a camera in their pocket, it’s super easy to get these pics. You just need to be alert and looking for opportunities. Right now is a good time to get pics of you doing tricks for Santa or elves.

When you start looking for photo ops, you’ll see them everywhere.

-Louie

Tooth Fairy Magic…

The other day I had a strange idea. I wanted to do a transposition between a tooth and a quarter. Using the toothfairy as presentation hook is a no brainer for this. The challenge was that I wanted one of them to be held in the spectator’s hand and obviously they are very different shapes.

The solution finally hit me, why not hand them a folding coin that was folded in thirds? This will have roughly the same shape as a tooth, and have some textures like a tooth. Once that was figured out, the rest of the mechanics were pretty simple. Here’s me trying it out:

It works! This was a great solution for strange problem.

– Louie