Solving the Cube…

In my continuing quest to make things play bigger, I’ve finally altered a trick that I used close up to hopefully have it play for a bigger audience. The trick started as Huge Shelley’s iCube trick. The problem with his set up was that I found using my phone as a thumper was unreliable. The bluetooth would drop, or I wouldn’t necessarily be able to feel the vibrations.

I then got a ProMystic MD Mini, which is completely reliable. I just didn’t like the look of the cube, so I put the guts into the shell that came with icube and have a little prop that works great for close up!

The next challenge is how to make it play bigger. Right now the cube is about 3/4 of an each on each side. The obvious way it to scale it up to a bigger cube. For that I picked up a Meffert’s Oskar’s Treasure Cube with is a Rubik’s Cube that had a compartment inside.

I put the MD Mini that’s inside the iCube shell into the treasure cube and secured it with sponge. Now I that can be seen in a bigger venue. The next challenge is to figure out a way to show the selected side of the cube. This was a bit of a challenge because if it’s held up and show by someone in the audience, they won’t necessarily do a good job displaying it.

To solve this, I went with an obvious solution, and that’s to put the die is a box with a lid.

The box was a very quick and simple 3D print to design and it only displays one side. No I can simply ask the person to, “take off the lid and show it to the audience” and there’s no issue with displaying the selected color. As a bonus, if the trick ever fails me, I now have an out. I can use it like the old color block trick where you put the lid on the side!

One thought on “Solving the Cube…”

Leave a Reply

Your email address will not be published. Required fields are marked *