Little Things…

With a magic trick, all of the little things matter and they matter a lot! There’s a trick that I do in the show that when I started doing it, it used three thumb thumb tips. At one point I had to remove something from one of them, and put it into a different thumb … Continue reading “Little Things…”

With a magic trick, all of the little things matter and they matter a lot! There’s a trick that I do in the show that when I started doing it, it used three thumb thumb tips. At one point I had to remove something from one of them, and put it into a different thumb tip!


After really thinking about how the trick flowed, I managed to figure out a way to do it with only two thumb tips. One of the tips is a XXL thumb tip, and that solved the the problem of having to move something from one thumb tip to another, and it also meant one less time that I need to go to the bin on my table.

The next problem was prop management. On my table, there’s a bin. In that bin are my props, and the thumb tips used to just lay on the bottom of the bin. The problem is that they roll around, especially if my table is carried out, and not preset. I solved this by 3D printing this holder:


The foot on the holder is to provide a more steady base, so that it can’t tip over. Hopefully the thumb tips will stay upright!