Yesterday I posted about wanting to make a Remote Control Party Popper. I ended redesigning the party popper holder, so that it would fit more securely on the board. The one on the right is the new design, and it’s got a flat bottom to site flat on the board.
You’ll notice that I’m using spools to coil in the string. My first attempt was a lever that pulled them, but I couldn’t get the torque I needed, however the strings constant pull worked well to pull the strings.
Here’s the working version:
Having two that shoot off makes it feel “bigger” and having the second one staggered I think makes it hard to miss. I think people will hear the bang from the first one, but might miss the visual of the streamer. The second one should be seen as the first one will have gotten the attention.
I think if I made it again, I would put the two motors in the same motor housing, which would allow me to make it a little bit smaller.
-Louie