Russian Shell Game – Tutorial…

I’m trying to get ahead of orders and have a few more things in stock. Yesterday I needed to make a new mold for my Russian Shell Game trick. I figured I show you what goes into it. I had already made the bottom part of the mold, so here’s how the second half was made.

I put left the shells in the mold and gave it a coat of mold release, otherwise the silicone would stick, and I’d just have a block of silicone with some shells inside that I couldn’t get out.

russian shell game by louie foxx


Then I measured out the silicone and mixed it up:

russian shell game by louie foxx

That gets poured into the existing mold:

russian shell game by louie foxx

Once it poured, I need to wait until it’s fully cured:

russian shell game by louie foxx

And violia! I’ve got the second part of my mold!

russian shell game by louie foxx

Now I take the resin, color it and mix it up, and that goes into the mold:

russian shell game by louie foxx

I put the top on the mold and let that cure until it’s finished hardening:

russian shell game by louie foxx

Once it’s done, I pop that out and I have the almost finished shells. They still need to be sanded. This is a quick way to produce the sets of these shells.

russian shell game by louie foxx

And here’s what the finished product does:

I hope this little walk through of what it takes to make some of my magic props will give you a little insight into the work that goes into prop building!
-Louie

Leave a Reply

Your email address will not be published. Required fields are marked *